News

Average-speed cameras vandalised before switch-on: how the system works

Vandalism has delayed the activation of new average-speed cameras on State Highway 2 in Hawke's Bay until November. The cameras measure speed across a section of road rather than at a single point.

Go Media · · 2 min read

Average-speed cameras vandalised before switch-on: how the system works

New average-speed safety cameras on State Highway 2 in Hawke's Bay will not begin operating until around mid-to-late November after vandals cut down equipment before its planned activation.

The cameras, installed between Te Hauke and Pakipaki south of Hastings, had been scheduled to begin operating on 29 September.

NZ Transport Agency (NZTA) head of driving regulation Chris Rodley told 1News that the arms attaching the cameras to their poles had been cut off. One camera was subsequently recovered, while another remained missing, according to Hawke's Bay Today.

Police received a report on 7 September about damage to two cameras, one near Pakipaki and another near Ōtāne. Investigations were continuing, with no further findings announced in the reports.

NZTA is considering stronger security measures following the damage.

How average-speed cameras operate

Unlike conventional speed cameras that record a vehicle's speed at a particular location, average-speed cameras calculate how fast a vehicle travels across a section of road.

The system uses cameras at different points to measure the time a vehicle takes to travel between them. That information is used to calculate its average speed over the measured distance.

NZTA said drivers are issued speeding tickets only when their average speed across the monitored section exceeds the speed limit.

A single camera does not trigger a ticket merely because a driver briefly exceeds the limit at that point. The relevant measurement is the vehicle's average speed across the monitored section.

This also means motorists should maintain a lawful speed throughout their journey rather than slowing only when approaching camera equipment.

Hawke's Bay Today reported that NZTA planned to install warning signs before the monitored section to give drivers an opportunity to check their speed.

Why this section was selected

Rodley said the stretch of State Highway 2 between Te Hauke and Pakipaki had a high risk of fatal and serious-injury crashes.

NZTA's July 2025 speed survey found approximately 16 per cent of drivers on the section were speeding.

The agency said international experience suggested average-speed cameras could reduce deaths and serious injuries on suitable roads by around 48 per cent.

The damage is not an isolated incident. NZTA's mobile speed camera trailers were vandalised 18 times during their first year on the roads, 1News reported.

Earlier in October, an average-speed camera on East Coast Road in Redvale, north of Auckland, was also cut down.

The Hawke's Bay cameras have not yet begun enforcement. Their expected activation is now mid-to-late November, subject to completion of repairs and commissioning.

Police have asked anyone with information about the State Highway 2 damage to contact 105, quoting file number 260908/3034, or provide information anonymously through Crimestoppers on 0800 555 111.

Sources

Asian Insider newsletter

Stay across New Zealand.

Free email updates with news and stories from New Zealand and its Asian communities.

Subscribe free